
Solid Tungsten DLC Coated Upshear Cutter for ACM – Single Flute
Brand | KONIG |
Individual/Set | Individual |
No. Pieces | 1 |
Material | Solid Tungsten |
Shank Type | Straight |
Tip Coating | DLC |
Cut Type | Upcut |
No. of Flutes | 1 |
Brand | KONIG |
Individual/Set | Individual |
No. Pieces | 1 |
Material | Solid Tungsten |
Shank Type | Straight |
Tip Coating | DLC |
Cut Type | Upcut |
No. of Flutes | 1 |
Slight upshear angle
This allows for good chip extraction but doesn’t have the aggressive upcut action that makes smaller parts move.
DLC Coating
‘Diamond Like Coating’ is a thin coating that has the same properties as diamond. This means the sharp edge stays sharp for longer as it can cope with the abrasion and heat build up a lot better. Gives the cutter a slippery finish to stop the soft aluminium and plastic from sticking to the cutter.
Open Flute design
Better chip extraction means less heat build up. This in turn means a longer lasting cutter and better edge finishes less clean-up work needed.
Code | Diameter | Cut length | Shank Size |
20-59550 | 3.2mm | 6.4mm | 6.4mm |
20-59565 | 4mm | 6.4mm | 6mm |
20-59567 | 4mm | 10mm | 6mm |
20-59554 | 6.35mm | 6.4mm | 6.35mm |
It gives the best of both worlds: nice, clean cut while minimising the risk of small part movement.
Q: Whats the advantage of DLC?Longer life, reduced adhesion of Aluminium and plastic chips
Fast Overnight Delivey
Accurate Technical Support
Same Day Dispatch
Before & After Purchase Advice
Free Shipping On Orders
Over $100